Sold Catamaran 2009 ROBERTSON & CAINE Leopard 47 PC Full Specifications

Number of cabins: 4 - with double berths and en suite head and shower
Number of single berths: 2 - Crew’s Quarters
Dinette set lowers into a double berth

• Force 10 Oven, broiler and 3 burner stove propane
• Microwave
• Seafrost 2 door front-opening fridge/freezer 60USgal / 220Ltr, 12v refrigeration
• Double stainless steel sink
• Magma grill
• Dish & cutlery drying recess with drainage
• Corian cover for drying recess
• Separate garbage bin locker with top access
• Stowage space in shelf lockers & drawer units
• Corian bar counter
• Heat-resistant galley worktop surfaces

• Primary anchor is 55lb plow with 165ft chain
• Secondary Anchor is 33lb Delta with chain and rope
• Anchor bridle, shackles & hook
• Horizontal windlass with hand-held remote
• Anchor roller fitting with chain wear plates

• Plotter - Raymarine C80
• GPS - Raymarine C80
• Compass
• Log-speedometer - Raymarine ST60
• Depthsounder - Raymarine ST60
• Autopilot - Raymarine ST6000
• VHF - Raymarine Ray55
• 2 x Fuel tank gauges at helm position
• 2 x Ammeters at helm position

• AM/FM radio & CD player
• Speakers located in saloon, cockpit & fly bridge
• AC double outlets in cabins, galley, heads & switch panel
Samsung TV set in Salon

• Air conditioning/Heating - 3 CruiseAir, 40,000 BTU (2 new units)
• Battery charger - Victron 40 amp
• 1 x House battery isolator switches
• 2 x Engine starter battery isolator switches
• AC switch panel for shore power link-up
• Northern Lights Genset 9kW - fuel supplied by aft port tank with transfer capability
• 110/12 volt
• 5 Batteries - 3 house AGM 210 amp hour each, 2 engine AGM
• 1 x House battery isolator switches
• 110 volt Charger
• 110V Shore power pack & 2 x 50ft 30 amp shore power lines
• 12v DC switch panel
• 3 x 12v outlet sockets - 1 on switch panel, 1 on nav station & 1 on at helm station

• Port Engine
1) Cylinder #1 400 PSI
2) Cylinder #2 420 PSI
3) Cylinder #3 400 PSI
4) Cylinder #4 400 PSI

• Starboard Engine
1) Cylinder #1 400 PSI
2) Cylinder #2 440 PSI
3) Cylinder #3 440 PSI
4) Cylinder #4 440 PSI

Acceptable range for these engines are 500 to 300 psi

• Cooling system is freshwater heat exchange
• 2 x Exhaust skin fittings (stainless steel)
• 2 x Exhaust water locks
• 2 x Cooling water inlet strainer

• Morse electronic throttle and shift controls
• Shaft drive
• Balanced spade rudders
• Rudder stock in 17-4ph stainless steel
• Self aligning bearings
• Single station hydraulic steering system
• 2 x Hydraulic cylinders
• 2 x Tiller arms
• Emergency tiller (stainless steel
• Heat exchangers replaced March 2019

*Work that was just completed
• Starboard Yacht Mgmt - Heavy sand bottom to remove build up, Prime bottom of vessel with 2 coats tuff stuff epoxy primer and apply 2 coats sea hawk cukote blue
• Starboard Yacht Mgmt - Apply 2nd coat of anti-fouling
• Starboard Yacht Mgmt - Correct mfg hull and keel connection via grinding and prep fiberglass at seam, clean to receive vinylester resin, apply 1 layer 1708 and 2 layers of 1.5 matt
• Starboard Yacht Mgmt - Replace leaking thru-hulls/sea strainer on port and stbd side and black water tank valve
• Starboard Yacht Mgmt - Remove both shafts, replace all 4 cutlass bearings, replace tides marine shaft seals and add 2 spare seals per shaft, • Replace port strut and retarget, align motor; replace rudder seals and remount rudders
• Starboard Yacht Mgmt - Straighten both port and starboard shafts and remount with new bearings and seals
• Starboard Yacht Mgmt - Prep and apply prop speed to port and starboard shaft and props
• Starboard Yacht Mgmt - Bow above waterline has cracks and poor gelcoat repairs, grind and prep for lamination over seam, apply 2 layer 1.5 matt, body work, apply custom matched gelcoat
• Starboard Yacht Mgmt - Prep and repaint boot stripe
• Starboard Yacht Mgmt - Detail compound, polish sealant hull sides
• Starboard Yacht Mgmt - Replace anchor lower roller pin and improved design
• Starboard Yacht Mgmt - Replace AC unit with new upgraded unit
• Starboard Yacht Mgmt - replace corroded davit hardware with new stainless hardware
• Starboard Yacht Mgmt - Replace transom port and starboard rub railing
• Starboard Yacht Mgmt - Replace aft teak pontoon rub rail with matching white rub rail
• Starboard Yacht Mgmt - Replace Port engine throttle and gear control unit
• Diesel Doctor - new fuel injectors
• Diesel Doctor - new fuel impellors
• Navy Clean just detailed the complete boat
• Replace Port side A/C unit
• Head cleaning and two new sanitary hoses to holding tanks
• Replace shower and sink fixtures
• Replaced 2 mirrors in heads (bathrooms)
• Most scratches removed in plexiglass
• Replaced grill with Magma (large size)
• Replace TV with Samsung
• Repaired vinyl enclosure and zipper on flybridge
• Replace davit rigging and line with new three sleeve pully system to make it easier to use
• Replaced dock lines
• Replaced a couple fans
• Custom fit extra memory foam on all beds including the crew quarters (2 inches)
• Purchased new pillows and sheets
• Fixed shore power added breaker and new cords
• New generator battery
• Installed new red and blue color LED lights in cockpit and flybridge
• Purchased extra propane tank
• Installed new propane hose
• Installed combination lock
• Extra racks in heads behind the head
• Purchased new racks for shampoo in 4 showers
• Installed extra hooks for closes in cabins
• Fixed the refrigerator and Freezer
• Installed table on flybridge
• Purchased teak chairs for deck and used for interior salon