Sold Catamaran 2004 Manta MK II Full Specifications
$368,000 EMERALD DREAM St. Augustine Florida (FL)
Mon - Fri: 9:00 - 18:00
4005 N Federal Highway, Suite 200
Main Saloon:
L-shaped settee with storage under
Large adjustable dining table
U-shaped galley station with large counter, drawers and storage
Double sink with hot and cold water mixer
Top loading, 10 cubic ft. 60/40 refrigerator/freezer with 6" foam insulation and divider
Storage cabinets above and below in galley area
LED Courtesy Lights
Navigational area with chart storage
TV centre with wet locker below
Nicro solar powered vents on head hatches
Hella Turbo ventilation fans
2 x Cruisair Air Conditioning (reverse for heating) w/digital thermostat controllers
Port Hull (Owner's Cabin):
Owner’s stateroom with queen size bed facing fore and aft
Head area with separate shower stall and curtain, sink, mirror, locker
Electric fresh water marine toilet (Jabsco Quiet Flush)
Pantry storage adjacent to head inboard and outboard
Large bookcase in port companionway
At settee, large cedar-lined hanging locker, drawer space, and extra storage locker
Starboard Hull (Guest Cabins):
Forward cabin twin-size berth
Dual access head with sink, mirror, separate shower; curtain
Electric fresh water marine toilet (Jabsco Quiet Flush)
Large custom teak bookcase in starboard companionway
Aft cabin with queen size berth facing athwart ship
Splendide combo washer/dryer in fwd stbd cabin
Stove/Oven, 3 burner with storage below
Stainless steel splash guard mounted behind stove
12V cook top exhaust blower/vent over stove
Solenoid valve with remote
60/40, 10 cu. ft. Freezer-Refrigerator with digital temp displays, 12V
Hella Turbo 12 volt fan
Manual salt water faucet at galley sink
Microwave
Added storage shelves in Port Side Pantry area
2 dive tanks
Rigging tensioners
Custom Sail Covers
Plumbing and Electrical hook ups for water maker
Ferro Super Shield exterior gel-coat
Hull, deck, and bulkhead constructed of triaxial, biaxial, and unidirectional fiberglass with vinylester, isophthalic resins
Nida-core core in subsoles and bulkheads, all vacuum bagged for stiffness, strength and light weight
Hull fastened to deck chemically and mechanically
Collision bulkheads with watertight compartments in bow, stern and keels
Deck hardware reinforced with aluminum plates molded into lay-up
Twin fiberglass fin keels molded integral with hulls
Twin high density foam/fiberglass rudders with 2" dia. solid stainless steel shaft
Molded console with space for instrumentation and line bin at helm
Ritchie navigator binnacle compass
Bulkhead mounted stainless steel steering wheel. adjustable helm seat with foot rest
Nida-core core in subsoles and bulkheads, all vacuum bagged for stiffness, strength and light weight
Hull fastened to deck chemically and mechanically
Collision bulkheads with watertight compartments in bow, stern and keels
Deck hardware reinforced with aluminum plates molded into lay-up
Twin fiberglass fin keels molded integral with hulls
Twin high density foam/fiberglass rudders with 2" dia. solid stainless steel shaft
Molded console with space for instrumentation and line bin at helm
Ritchie navigator binnacle compass
Bulkhead mounted stainless steel steering wheel. adjustable helm seat with foot rest
Custom Stainless Steel anchor roller
Stainless steel corner bow rails with integral seat
28" stainless steel stanchions
Double life lines with boarding gates, port and starboard, mid-ships and aft
2 12" Stainless steel bow, spring line, and anchor cleats
Two Stainless steel transom rails
Two Stainless Steel stern boarding rails
Two stainless steel cabin top rails
Two stainless steel cockpit hand rails
Six Bomar aluminum opening deck hatches with screens
Eight Bomar aluminum opening ports with screens & Ocean sunshades
Tinted salon windows w/sunscreens
Bomar companionway door with locking latches and screen
Anchor chain locker
Vinyl coated polyester mesh trampoline
Molded non-skid on all deck surfaces
Polycast 3/8" acrylic tinted salon windows
Four large foredeck lockers with locking latches
Folding/telescoping swim ladders
Molded crossbeam and strut
Maxwell, VWC 1200, Electric windlass
5/8 nylon 20 ft. bridle and snubber with chain hook
2nd anchor, Fortress FX-23 w/30’ HT 5/16” chain & 250’ 5/8” nylon rode (3 stowage possibilities
Aluminum Spade anchor 150’ 5/16” all chain rode
Anchor saltwater wash down
Stern freshwater shower
Custom arch bench seat w/back-rest & cushions
Full set of cockpit cushions
Removable cockpit table w/storage bracket in stb berth
Aluminum radar arch/hardtop/dingy davit, welded, anodized, aluminum tube construction
Upgraded dinghy blocks & tackle w/dinghy outboard side capable of being run by main electric winch
Integral painted aluminum hardtop
Cockpit lighting
Strataglass windshield w/ opening center window
1 x Harken 42 two-speed self-tailing winch in cockpit, 12 volt
6:1 Lifting tackle
4 x Fiberglass storage boxes
Roll down vinyl half cockpit side curtains
VHF Standard Horizon GX 1260S with RAM mike at helm
Clarion cassette/ 6 disc CD player w/remote
Bose speakers in salon & cockpit
Glowmex Antenna at mast head
RayMarine Wind sp/dir, Depth, Speed,
Ray Marine C70 Autopilot and Plotter
GPS, autopilot, and VHF radio all interfaced
Raymarine radar, Compass
100 Gal aluminum water tank
2X20 Gal Holding tanks
2 Macerators, Jabsco
2 Shower sump pumps, Rule 500
2 Auto bilge pumps
2 Manual bilge pumps, Whale Gusher
2 Heads, Jabsco with "y" valve
2 TankWatch holding tank alarms
4 x Batteries, Battery isolation, Heart, Pathmaker 100/3
4 x Solar Panels, 75 Watt Shell
Controller for solar panels RV power products
3 Extra 12V outlets, 2 in saloon, 1 in nav station
Separate 12-volt starting batteries each engine
Charger, Statpower, Truecharge 40+
Air Cond. Pump Cruisair PMP 1000
Telephone and Cable connections
110-volt shore power with one 50 ft. 30 amp shore cords w/custom covers
Remote shutoff for propane
12-volt interior lighting
12-volt LED courtesy lights
Two 30 hp Volvo Penta MD 2030 diesel engines with sail drives (approx.250 hrs usage on each)
NextGen Marine 5.5kw generator w/remote start( approx 40 hours usage)
Groco intake macerator for diesel engines
Volvo 3 blade folding propellers
Battery Isolators with engine parallel switch
Whitlock pull/pull cable steering system
Emergency tiller
Electrical Meter, Heart, Link-10 on house bank
Two 60 amp alternators
Diesel fuel polishing/filter system on electric auto timer
Engine rooms blowers
Engine control panels in cockpit
Single lever shift/throttles
Full batten 10.3 oz high modulus dacron mainsail with two reefs
Boom bag sail cover
Lazy jacks mounted to spreaders and Boom basket
Strong sail track and slide system
Rigid boom vang
Dutchman boom brake
Self-tacking, full batten 8.3 oz high modulus dacron jib with Camber Spar
Jib cover, topping lift, and lazy jacks
Main halyard and jib halyard
Main sheet and jib sheet
All sheets lead to helm through deck organizer
Sheet stopper and Harken 44 two speed self-tailing electric winch
Extra main halyard
Jib downhaul system
Awlgrip painted aluminum mast and boom
Stainless steel rigging with chafe protection
All running rigging color coded
Extra line bag at helm
Flag halyards and cleats
All running hardware by Harken
Bosons Chair
Ships Bell
4 ABC Dry chemical fire extinguishers
Upgraded cabinet work to cherry and mahogany throughout
Upgraded counter tops to teal swanstone with teak edge inlays
Follow me TV satellite tracker
Dish TV satellite receiver, with shelf above wet locker
Door mounted Sharp Aquos 20” LCD TV located above wet locker
Clock, Barometer, and Hydrometer mounted on teak plaque located next to TV
Global Star Satellite Phone, with in cabin cradle mount with speaker, outside antenna and PC interface for email and weather data. Unit can be removed to be used as a handheld unit.
Upgraded batteries package from standard 4 to 6 batteries
Upgraded solar panels from 4 units to 6 units
Jack lines and shackles
Robe hooks mounted to Starboard frame in Owners Head
Robe hooks mounted to Teak frame in Owners Cabin
Hat hooks added to inside of Owners Cabin door
Clothing hooks added to inside of wet locker
Running rigging tensioners
2- 90’ scuba tanks mounted in forward starboard locker
Rail Mounted Magma Propane BBQ Grill- with custom cover
Two “Ice Cube” coolers with custom foam covers to be used as additional seating in salon
Extra halogen lighting mounted in salon over table
ACR satellite EPIRB interfaced with GPS
Louvers mounted over salon window
Inflatable fenders
PVC bumper boards
Fishing rod holders mounted on rear cockpit rails
Man over board line bags mounted in aft coc
Emerald Dream was put together by an owner who wanted her to be everything that she could be from the factory, fitted with many custom options. No option was spared, less the watermaker plumbed and wired but not installed.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors to investigate such details as the buyer desired validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice. Photos may not properly reflect the current condition of the actual vessel offered for sale. In some cases stock photographs may have been used.
Engine and generator hours are as of the date of the original listing and are a representation of what the listing broker is told by the owner and/or actual reading of the engine hour meters. The broker cannot guarantee the true hours. It is the responsibility of the purchaser and/or his agent to verify engine hours, warranties implied or otherwise and major overhauls as well as all other representations noted on the listing.
All dinghies are considered separate vessels and should have separate titles and documents. There is no guarantee as to the title of the dinghy on this vessel so Buyer accepts that while he may receive the dinghy included in the transaction, he may not receive the proper title to it.
Copyright© The Catamaran Company
All rights reserved.
Recommended Boats